我们将向您展示如何调整你的盐度探针在我们第九集的海王星顶点系列。步骤1:把探头从你的坦克,吹水的结束,让它干燥。我建议让它坐几个小时完全干燥。这是非常重要的,没有水分呈现在探针之间的联系。第二步:点击电导率校准按钮(它应该说干电导探针和结算数量)。步骤3。一旦停止移动10 - 20秒数,点击确定。提示:在此期间,浮动校准解决方案在坦克或油底壳的临时柜。第四步:选择你校准的解决方案。提示:绝大多数的盐水水族馆业主将使用一个53000的解决方案是一千分之三十五,或大约1.026比重。 Step 5. Tear or clip the corner off the solution and insert probe. Hold the calibration solution with the probe in the tank so it maintained the same temp as your temperature probe (this is critical). Step 6: Ensure one of the air holes on the probe is turned upward. Give it a few light taps with your finger to get any air out, and wait for the settling number to stop changing for 10-20 seconds. Try tapping the probe again to see if there is any air left - if the number doesn't change, hit OK. TIP: The probe is fragile, so be sure to have a light hand when it comes to tapping air out. Step 7: Confirm your probe is calibrated by leaving it in the solution and checking your home screen, it should read very closely to thirty five parts per thousand. Remember if you have any issues with this process, the first step is to remove the probe completely and isolate the cord from electrical noise. Throw the temp and salinity probe in the same cup to completely remove the stray voltage issue and see if the if the readings look reasonable now. If you have any questions about this process or tips for your fellow reefers check out the comments area down below. Make sure to hit subscribe to get future episodes in our Apex series! Check out the entire Apex line: http://brs.li/neptuneapex Watch the whole playlist: https://www.youtube.com/playlist?list=PLBaMLrfToJyz8091y-PoECoUo5QfMGg1S Connect with us on Facebook: http://www.facebook.com/BulkReefSupply Check out our pics on Instagram: http://instagram.com/bulkreefsupply