我们要去控制光的选项中找到“控制型”下拉时顶点融合云接口编程的一个出口。通过选择“光”的选项,你会得到一堆预装控制字段一般大多数人会使用任何类型的光。我们要专注于你的主灯为你的水族馆。选项1:回退这个选项要求如果能量棒得到断开Apex基本单位,你会想要出口违约或关闭?我们要选择“关闭”,这样如果有几天在这发生了我们的珊瑚不会煮。选项2:在时间选择你想让你的光来。提示:大多数人之间保持一段照明8 - 12小时。通常那些灯,接近12个小时上下坡道逐渐在每个照明时间的开始和结束,或使用各种灯,不同强度(如卤化物和t5)。选项3:时间选择你希望你的光关掉。记住,时间是衡量一个24小时时钟。提示:日光周期不需要匹配实际的白天在家里。 Find a schedule that matches your lifestyle so the lights are on when you're actually home. Option 4: Shutdown Probe This feature will turn off your lights based on the temperature of your tank. Unless you have more than one temp probe, you will only have one option which will say 'temp'. Option 5: Shutdown Value The shutdown value is the temperature at which point your lights will shut off. TIP: Most people will set their shutdown value/temp to a few degrees above where they want their tank to be. Option 6: Hysteresis This option relates back to the shutdown probe and value, and tells the controller how long the light should remain off after a shutdown is triggered due to temperate. This is set to 30 by default. Hit 'Send to Apex' when you're finished, and your light outlet will be programmed moments later. One final note on what's happening here: the control interface is writing lines of code for you based on what you input. If you go back to the outlet, you can see the lines of code by hitting the advanced tab. If at some point you want to do something more advanced, like use the I/O switch box to turn on/off based on a hard button, you could add some additional command lines here. If you have questions or advice for your fellow reefers checkout the comments area down below. Don't miss our next episode, hit that subscribe button! :) Check out the entire Apex line: http://brs.li/neptuneapex Watch the whole playlist: https://www.youtube.com/playlist?list=PLBaMLrfToJyz8091y-PoECoUo5QfMGg1S Connect with us on Facebook: http://www.facebook.com/BulkReefSupply Check out our pics on Instagram: http://instagram.com/bulkreefsupply